20 introduction – Cabletron Systems SmartSTACK 100 User Manual
Page 30
1-20
Introduction
ELS100-16 > help
ELS100-16TX Local Console Manager
help or ?
this menu
status [PORT-RANGE]
to display unit or port status
baud [BAUD-RATE]
to change the console baud rate
exit or logout
to logout
erase
to erase configuration information
ident
to display unit identification
ipaddr [PORT# IPADDR [MASK]]
to set or display IP addresses
addresses display [any] [ADDR [MASK]]
to display learned addresses
bridge [PORT-RANGE [OPTIONS]]
to set bridging methods
clearstats
to clear all port statistics
trunk [PORT-RANGE [{on|off}]]
to set or display trunking status
enable [PORT-RANGE [noRIP]]
to enable a set of ports
disable [PORT-RANGE]
to disable a set of ports
community
to change the password/community name
sttimer [TIMER-VALUE]
to set or display st age timer
workgroup [NAME [delete|PORT-RANGE [INFO]]]
to set or display workgroups
speed [PORT-RANGE [{auto|10|100}]]
to set or display speed
duplex [PORT-RANGE [{auto|half|full}]]
to set or display duplex mode
mirror [PORT# {Rx|Tx|both|off}]
to set or display port mirroring
time [SystemTime (HHMMSS)]
to set or display the system time
date [SystemDate (MMDDYYYY)]
to set or display the system date
reboot (SECONDS|off)
to reboot the unit after seconds
arp display
to display the arp table
route display [IPADDR]
to display routing table information
ping [-rvsx] HOST [DATASIZE [COUNT]]
to send ICMP ECHO_REQUEST pkts to tgt
traplog
to display the most recent SNMP traps
ELS100-16 >