CFM Corporation A053041 - Manual (Page 26)

Match Light
Access Hole
MATCH LIGHTING
Repeat steps 1 to 4 of “Igniter Lighting
Instructions.”
STEP 5. To match light: push down and turn
the RIGHT burner control knob
counterclockwise to the high setting.
STEP 6. IMMEDIATELY strike a match and
position the burning match through match
lighting hole in the grill bottom. Extend the
flame near a burner port in the bottom edge of
the burner. The burner should light. (A match
holder is supplied in the hardware pack to hold
and extend the match into the burning
chamber.)
To light the other side of the burner, press in
and turn the opposite control knob. The flame
will track around the burner. Allow grill to
preheat with the grill lid closed for five to ten
minutes before cooking.
CAUTION: Do not touch any hot grill parts.
The outside of the grill bottom becomes very
hot during use. It may be necessary to use
protective gloves.
STEP 1. Turn the burner-control knob(s) off.
The burner flame will go out.
STEP 2. Turn off the top L.P. cylinder valve
by turning the knob in a clockwise direction
until it stops.
IMPORTANT: Always have the gas shut off at
the L.P. cylinder valve when the grill is not in
use. The L.P. cylinder has a leak detection
feature which will restrict the amount of gas
flow to the burner if the
tank shut-off valve
has not been
turned off
prior to the
next use.
HOW TO SHUT OFF THE GRILL
Locating the Match Lighting Hole
The match lighting access hole is located
underneath the bottom of the grill tub.
28
Lighting Instructions
IMPORTANT: The match lighting hole is
found under the front right corner of the grill
bottom. When match lighting the grill, use the
gas control knob on your RIGHT-HAND side
(closest to the match lighting hole).