CFM Corporation A053041 - Manual (Page 15)

16
1.
2.
3.
4.
Holding the grill head upright, slightly rotate
the knob side down and set it onto the frame
assembly. The knobs will insert through the
control panel first, then rotate the grill head
down until it rests properly onto the frame.
Line up the 4 bolt holes near the
inside corners of the grill tub.
(The lid will need to be opened
to access the bolt locations.)
Loosely insert all of the bolts with
washers and gaskets.
After all bolts are threaded, make sure the
control knobs centered and securely tighten
the bolts.
Assembly Step 7 - Installing the Grill Head
Grill Head
Assembly
Tools Needed:
LOCATE THESE PARTS:
M6x15mm
Bolt (4)
M6 Flat
Washer (4)
Bolt
Gasket (4)
Phillips head screwdriver
USE HARDWARE ”F”
A
A
C
B
B C