CFM Corporation A053041 - Manual (Page 12)

13
1.
2.
3.
4.
Insert the legs of the wire tank retainer
into the mounting brackets inside the grill
legs. The wire tank retainer must be
mounted on the wheel side of the grill.
Insert the ends of the wire x-brace
into the mounting
holes located
near the
middle of
the grill legs
and thread
a M6 wing
nut onto
each end.
Thread M6
wing nuts onto
the ends of the
wire tank retainer.
Align the center hole of the x-brace wires,
insert the M4 bolt through both wires, and
thread on the M4 wing nut as
shown above right.
Assembly Step 4 - Install the Tank Retainer
Wire
X-Brace
Wire Tank
Retainer
LOCATE THESE PARTS:
M6 Wing
Nut (6)
C
M4x10mm
Bolt (1)
B
M4 Wing
Nut (1)
A
USE HARDWARE ”C”
B
A
C
C
Phillips head screwdriver
Tools Needed: