CFM Corporation A053041 - Manual (Page 13)

B
A
14
1.
2.
3.
Position the modesty panel between the front legs of the
assembly. Align the mounting tabs with the bolt holes in
the legs.
From the back side of the assembly, insert the
M4 bolts through each of the mounting holes
and thread on the M4 KEPS nuts.
insert the bolt indicated - it will be installed
during a later assembly step.
Position the Tank Heat Shield
between the front and rear
x-frame assemblies as shown
below.
DO NOT
yet
4.
5.
For each mounting hole, insert M4 bolts and
thread on M4 KEPS nuts.
Securely tighten all the bolts. Remember to set
aside the remaining bolt and nut for a later step.
Assembly Step 5 - Attach the Modesty Panel
Modesty
Panel
Tank
Heat
Shield
LOCATE THESE PARTS:
M4 KEPS
Nut (6)
A
M4x15mm
Bolt (6)
B
USE HARDWARE ”D”
Phillips head screwdriver
Tools Needed:
7mm Wrench
A B
IMPORTANT! The Tank Heat Shield
must be properly installed to provide an
additional precautionary safeguard.