Intek RheoVac CMS - Manual (Page 15)

September 2013 11 © Intek, Inc. 2013
Revision D
2.2 ELECTRICAL CONNECTIONS
A typical system with a model 950 RheoVac MSP is shown in Figure 4. Additional instruments
can be connected to the RS-485 bus per the EIA-485 standard.
Figure 4: Typical system configuration with one RheoVac MSP
IMPORTANT — Inspect and VERIFY these electrical connections carefully. Improper
connection could damage electronic components and sensor function. If additional holes need to be
drilled in the processor enclosure, remove the electronics subassembly (mounted on a mounting plate)
and temporarily store inside an ESD bag in a safe, clean place. Do not drill with electronics boards
inside the enclosure.