Intek RheoVac CMS - Manual (Page 36)

September 2013 32 © Intek, Inc. 2013
Revision D
MESSAGE CODE
Description/Symptom
PROBABLE CAUSE ACTION
OUTPUT ERROR
CODES
PT Probe Message Codes
MSG-2
Reserved
MSG-3
Reserved
MSG-4
Reserved
MSG-5 or (CalX)
Calibration Expired
1. Probe Calibration Expired
1. Contact factory for
Recalibration
N/A
Flow Meter Message Codes
MSG-2
Reserved
MSG-3
Reserved
MSG-4
Reserved
MSG-5
Sensor Issue
1. No sensor communication
2. Irregular sensor data
1. Contact factory -101
Thermocouple Message Codes
Open
TC Circuit Open
1. Loose connection
2. Broken wire
1. Check wiring at the electronics
2. Contact factory
-500
Under
TC Value Under Range
1. Temperature below 32°F 1. Contact factory -501
Over
TC Value Over Range
1. Temperature above 212°F 1. Contact factory -502
Error
General Error
1. Loose connection
2. Component failure
1. Check wiring at the electronics
2. Contact factory
-504
MA (4-20mA DAQ) Message Codes
Open
MA Circuit Open
1. Loose connection
2. Broken wire 1. Check wiring at the electronics
2. Contact factory
-500
Under
MA Value Under Range
1. Output below range 1. Contact factory -501
Over
MA Value Over Range
1. Output above range 2. Contact factory -502
Error
General Error
1. Loose connection
2. Component failure 1. Check wiring at the electronics
2. Contact factory
-504