Intek RheoVac CMS - Manual (Page 14)

September 2013 10 © Intek, Inc. 2013
Revision D
2.1.2 PT Probes
The PT probe(s) is installed through a ball valve similar to that shown in Figure 2 and Figure 3.
Special instructions, where applicable, are provided by Intek (see SECTION 8 - CUSTOM
INFORMATION).
2.1.3 Rheotherm CWFF Meters and Temperature Sensors
These instruments are installed by Intek Inc. or under Intek Inc.’s supervision. The installation
ensures proper seating/anchoring of the sensors in the selected locations. Wiring is fully coated using
epoxy coating that is proven for underwater application.