Canon A2000 IS - Manual (Page 23)

Taking Pictures
23
Shoot.
● Press the shutter button fully.
X The camera will play the shutter sound
and shoot. The flash will automatically fire
in low light conditions.
X The indicator will blink green while the
image is recorded to the memory card.
X The image will appear on the screen for
about two seconds. You can continue
shooting while the image displays.
• the camera does not play any sounds?
Pressing the
⁄ button while turning on the camera power will turn off all
sounds except for warning sounds. To turn on sound, press the · button,
select the 3 tab, then select [Mute]. Use the qr buttons to select [Off].
• the image comes out dark even the flash fired when shooting?
Subject is too far away for the flash to reach. Shoot the image within the
effective flash range of approximately 30 cm – 3.5 m (1.0 – 11 ft.) at maximum
wide angle (
j side), and approximately 50 cm – 2.0 m (1.6 – 6.6 ft.) at
maximum telephoto ( i side).
• the indicator blinks orange and the camera only beeps once when the
shutter button is pressed halfway?
Your subject is too close. Move about 50 cm (1.6 ft.) or more away from your
subject. Press the shutter button again halfway, making sure the indicator does
not blink orange before taking the picture.
• the screen turns off when you take an image?
When flash recharging begins, the indicator may blink orange and the screen
may turn off. When recharging ends, the screen turns on again.
• the lamp lights?
The lamp (Red-Eye Reduction Lamp) lights in order to reduce the red-eye effect
that occurs when shooting in dark conditions using the flash. It also emits when
assisting the focus (AF-assist Beam).
What if...