GTCO Super L VI - Users Guide - Manual (Page 14)

Super L VI 14
buttons through are active only after clicking on the button to activate
Select Mode.
Resetting Super L VI
The Super L VI can be reset by:
 Turning off the power switch on the Controller Connector Panel
 Unplugging and re-plugging the power supply
 Clicking on the SuperSet Menu.
When one of these events occurs, the Super L VI will revert to the configuration that was
last defined. Any remote commands that were active before the reset will be lost.
Turning the Alarm Off and On
You can disable the alarm if you do not want to hear a tone each time the transducer
button is pressed. When the alarm is off, you will still hear diagnostic and menu-related
tones.
To turn the alarm Off or On:
 Click on the button to toggle the tones Off or On.
Testing the Active Area
To test the Super L VI grid, or Active Area:
1. Using the transducer, click on the button to activate the test.
2. Move the transducer around in the Active Area. If there is a break in the grid or the
transducer is out of prox, the tablet will beep.
3. Click the button again to end the test.
NOTE: The following is relevant only when connecting via an RS-232 serial installation. USB
does not require configuration.