GTCO Super L VI - Users Guide - Manual (Page 11)

Super L VI 11
USB Connection
Super L VI USB port connection is USB 1.1 and 2.0 compatible. When the digitizer is
connected to the USB port, Windows will recognize that there is a new device connected. If
Windows displays the Found New Hardware prompt, follow the onscreen instructions to
complete the driver installation.
1. Connect the interface cable to the USB jack on the Super L VI Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it. Attach the other
end of the USB cable to any one of the USB ports
on your computer or USB
hub.
2. Turn the power switch on. The green Indicator Light will begin blinking and the
digitizer will beep four short tones, indicating it has power. See the Super L VI Tones
section for a complete table of the Super L VI tones.
NOTE: Power is supplied through the USB port. No additional power source is needed for
this installation.
QuikRuler III™ Connection
The Super L VI has a connection socket for the QuikRuler III. The QuikRuler III is a portable
measuring system that quickly and accurately automates blueprint takeoff and drawing
measurement processes. Contact GTCO CalComp by Turning Technologies for price and
availability.