GTCO Super L VI - Users Guide - Manual (Page 12)

Super L VI 12
Transducer Connection
1. If you are using a corded transducer, connect the cursor or pen to the appropriate
jack on the digitizer’s Connector Panel. The connector is keyed and will fit only the
correct jack. Do not force it.
Optional RS-232 Serial Connection
1. Connect the RS-232 serial cable to the serial jack on the Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it. Attach the 9-pin
connector of the serial cable to the serial port on your computer.
2. Plug the power supply into an AC outlet. Connect the power supply to the
appropriate jack on the Super L VI Connector Panel. Turn the power switch on. The
green Indicator Light will begin blinking and the digitizer will beep four short tones
(see the Super L VI Tones section for a complete table of Super L VI tones), indicating
it has power.
Tablet Power On
The Super L VI power switch is located at the rear of the tablet on the Connector Panel.
When turned on, the Super L VI’s Indicator Light will begin blinking and four Success tones
will sound.
If you are using a cordless transducer, turn it on by pressing any button on the tool. The
Indicator Light will glow steadily when the transducer is inside the Active Area of the tablet.
When the transducer moves outside the Active Area, the Indicator Light will go off.