GME TX4600 - Manual (Page 23)

TX4600 INSTRUCTION MANUAL PAGE 23
Channel Selected 1 2 3 4 5* 6 7 8 41 42 43 44 45 46 47 48
Receive Channel 1 2 3 4 5* 6 7 8 41 42 43 44 45 46 47 48
Transmit Channel 31 32 33 34 35* 36 37 38 71 72 73 74 75 76 77 78
To preselect a CTCSS Tone
1. Press and hold the MENU key until the radio
beeps.
2. Briefly press the MENU key repeatedly until
‘CTCXX’ is displayed, where XX is a number
between 1 and 50 or oF.
3. Press the or key to select the required
CTCSS tone number (see CTCSS Tone Chart
on page 25). If the CTC38 tone set is enabled
there will be 38 tones available otherwise
there will be 50 tones.
NOTE: To display the CTCSS frequency instead
of the tone number, briefly press the SQL key.
The CTCSS frequency (in Hz) will be displayed.
Briefly press the SQL key again to return to the
tone number.
CTCSS Tone Number Displayed
CTCSS Tone Frequency Displayed
4. To turn CTCSS tones OFF select CTCoF
5. Press and hold the MENU key until the radio
beeps, to store the setting.
LAMP COLOUR
The display lamp can be set to Orange, Red or
Green to match other equipment you might have
installed or to satisfy personal preference.
1. Press and hold the MENU key until the radio
beeps.
2. Briefly press the MENU key repeatedly until
‘LAMP’ is displayed.
3. Press the or keys to cycle through the
available colours of Orange, Red or Green.
4. Press and hold the MENU key until the radio
beeps, to store the setting.
BATTERY/S-METER/ALPHA
SELECTION
The TX4600 has the option of displaying either
the battery voltage or the incoming signal
strength (S-meter) in the area beneath the
channel display. In addition, when ‘Listening’
channels (81 – 99) are selected, the radio
provides an extra option of displaying the
frequency of the selected user channel or a
custom ALPHA label (when ALPHA mode
is selected).
The ‘Listening’ channels are treated
independently to the normal UHF CB channels
in that you can for example, select S-Meter or
Battery Voltage on Channels 1 – 80 yet display
the channel frequency (or an ALPHA label) on
channels 81 – 99.
To display S-Meter or Battery Voltage on
channels 1 – 80
1. Select a channel from 1 – 80.
2. Press and hold the MENU key until the radio beeps.
3. Briefly press the MENU key repeatedly until
‘S-MET’ (S Meter) or ‘bATT’ (Battery) is
displayed.
42333-8_TX4600 IM.indd 23 28/08/13 11:22 AM