GME TX4600 - Manual (Page 13)

TX4600 INSTRUCTION MANUAL PAGE 13
labelled ‘c0’ to ‘c9’.
To store a SelCall Ident in memory
1. Press the CALL button to select the CALL TO
mode. ‘CALL TO’ is displayed along with the
last sent or received SelCall Ident.
2. Press channel selector keys to select the
required Ident memory (locations ‘c0’ to ‘c9’).
TIP: If the radio displays letters instead of
numbers in the SelCall Ident position, your radio
is in ALPHA mode. To switch back to NUMERIC
mode, briefly press the F (Function) key followed
immediately by the ALPHA key. A low beep will
be heard and ’NUMER’ will be displayed for a
few seconds in the Ident position.
3. With the required memory location displayed,
enter the SelCall Ident as follows:
(a) Press and hold the F key until the radio
beeps. The right-hand digit of the SelCall
Ident will flash.
(b) Press the or keys to select the required
number in the flashing digit position.
(c) Briefly press the F key again to select the next
digit position.
(d) Repeat steps (b) and (c) to enter all 5 digits
as required.
(e) Now press and hold the F key. The entire
Ident will flash for a few seconds then the
radio will beep as the new Ident is stored.
RECALLING SELCALL IDENTS FROM
MEMORY
1 Press the CALL button to select the CALL TO
mode. ‘CALL TO’ is displayed along with the
last sent or received SelCall Ident.
2. Press the or keys to select the required
Ident memory in locations ‘c0’ to ‘c9’.
3. When the required SelCall Memory is displayed,
press and hold the CALL button to send the
Ident.
NAMING YOUR SELCALL IDENTS
The TX4600 allows you to name each SelCall
Ident using a 5 character ALPHA name. The name
is stored in memory along with the Ident making
it easier to identify whose Ident you are recalling
from the memory. If an incoming SelCall matches
one of those in your radio’s memory, the name
can be displayed instead of the SelCall Ident.
DISPLAYING ALPHA NAMES
To display the Selcall’s ALPHA Name, you must
have the radio’s ALPHA display mode selected.
To toggle the ALPHA display mode, briefly press
the F (Function) key followed by the ALPHA
key. ‘ALPHA’ or ‘NUMER’ will be displayed for 2
seconds below the channel display to indicate the
selected mode.
TIP: The normal channel display may give no
indication of which display mode is selected. The
selected mode will only become obvious when
displaying Idents.
ENTERING AND STORING A SELCALL
NAME
NOTE: Before adding an ALPHA Name to a
SelCall Ident, you should first store the required
Ident in memory as described above under
‘STORING SelCall IDENTS’ on page 12.
1. Ensure the ALPHA mode is selected (briefly
press the F key followed by the ALPHA key to
toggle ALPHA mode).
2. Briefly press the CALL button. The CALL TO
mode will be selected and the last-sent SelCall
memory location will be displayed.
3. Press the or keys to select the required
SelCall memory (locations c0 to c9). If no
ALPHA name has been programmed for that
memory the radio will probably display ‘- - - -
-’ otherwise it will display the last ALPHA
name programmed into that memory.
4 With the required memory location displayed,
enter the required ALPHA name as follows:
(a) Press and hold the F key until the radio
42333-8_TX4600 IM.indd 13 28/08/13 11:21 AM