GME TX4600 - Manual (Page 15)

TX4600 INSTRUCTION MANUAL PAGE 15
To cancel the Alarm and listen on the
Channel
Briefly press the QUIET button (if QUIET has been
activated). The alarm will stop beeping and the
channel will remain open to any incoming signals.
QUIET MODE
The QUIET mode mutes the TX4600’s receiver to
prevent any incoming signals from being heard
in the speaker until your SelCall Ident is received.
In this way you can monitor a busy channel
for personal calls without being disturbed by
unwanted signals.
If your SelCall Ident is received, the QUIET mode
is then cancelled and all incoming signals are
heard in the speaker.
SETTING UP THE QUIET MODE
To setup the QUIET mode you must first ‘tag’
the channels that you want to stay Quiet, then
activate the QUIET mode. Once the QUIET mode
is activated, the channels you have tagged will
remain Quiet to all incoming signals unless your
SelCall Ident is received. Channels not tagged
will remain open to all signals and will operate
normally.
To tag individual Channels for QUIET
operation
1. Select the required channel using the or
keys.
2. Briefly press the F key then press and hold
the QUIET key until the radio beeps. ‘Q’ will
appear to the right of the channel display
indicating the selected channel is now tagged
for Quiet operation.
To remove the QUIET Tag from individual
Channels
1. Select a channel that has been tagged for
Quiet operation. ‘Q’ will be displayed.
2. Briefly press the F key then press and hold
the QUIET key until the radio beeps. ‘Q’ will
disappear indicating this channel is no longer
tagged for Quiet operation.
ACTIVATING THE QUIET MODE
1. First, select a channel that has been tagged for
Quiet operation (you cannot activate the Quiet
mode unless you have selected a ‘tagged’
channel). ‘Q’ will be displayed.
2. Now briefly press the F key followed by the
QUIET key. ‘QUIET’ will appear on the display.
Now all channels that were tagged for Quiet
operation will be operating in the Quiet Mode.
DE-ACTIVATING THE QUIET MODE
1. Select any channel that has been tagged
for Quiet operation. ‘Q’ and ‘QUIET’ will be
displayed.
2. Briefly press the F key followed by the QUIET
key. ‘QUIET’ will disappear from the display
and all channels that were tagged for Quiet
operation will now operate normally again.
RECEIVING SIGNALS IN THE QUIET
MODE
• If a normal signal is received on a QUIET
channel, the channel will appear busy (the
‘BUSY’ indicator will be visible) but no sound
will be heard from the speaker. This means you
will not be disturbed by the signal.
• If a normal signal is received on an Open
channel (one that is not tagged with ‘Q’) the
signal will be heard in the usual way.
• If a signal containing your SelCall Ident is
received on any channel - Open or QUIET - the
QUIET mode will be cancelled and the alarm
will beep to alert you to the call. In addition,
the callers Ident or ALPHA name will be
displayed. All channels will now be open for
normal transmission and reception.
42333-8_TX4600 IM.indd 15 28/08/13 11:21 AM