GMC 2011 Canyon - Manual (Page 117)

Black plate (3,1) GMC Canyon Owner Manual - 2011
Instruments and Controls 5-3
Move the band to one of the
following positions:
8 (Mist): Single wipe, move the
band to
z
and then release it.
Several wipes, hold the band
on
z
longer.
N
(Adjustable Interval Wipes):
For a delayed wiping cycle. Turn the
band up for more frequent wipes or
down for less frequent wipes.
6 (Low Speed): Slow wipes,
turn the band to the first solid
position past the delay settings.
1 (High Speed): Fast wipes,
turn the band to the second solid
position past the delay settings.
9
(Off): Turns the wipers off.
Clear snow and ice from the wiper
blades before using them. If frozen
to the windshield, carefully loosen or
thaw them. Damaged wiper blades
should be replaced.
Windshield Washer
{
WARNING
In freezing weather, do not
use your washer until the
windshield is warmed. Otherwise
the washer fluid can form ice on
the windshield, blocking your
vision.
Q L
(Washer Fluid): Push the
paddle on top of the multifunction
lever to spray washer fluid on the
windshield. The wipers will clear
the window and then either stop or
return to your preset speed.
Compass
Compass Operation
Press
Y b
or depending on the
mirror, press
O
once to turn the
display on or off.
Compass Calibration
The compass may need
calibration if:
. CAL is displayed while driving in
the vehicle.
. After approximately five seconds,
the display does not show a
compass heading, N for North,
for example, there may be a
strong magnetic field interfering
with the compass. Interference
can be caused by a magnetic
antenna mount, magnetic
note pad holder, or a similar
magnetic item.
. The compass does not display
the correct heading and the
compass zone variance is set
correctly.