And the supplied application, Connections, Basic operationai test – Roland RSS-10 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Example Setup 4 How to control the RSS-10 using a computer
and the supplied application
What to prepare
Connections
In addition to what was prepared for Example Setup 1 or 2,
Apple Macintosh computer or a computer compatible with Microsoft Windows
Connection cable for the computer and RSS-10 or MIDI Interface and MIDI cable
There are two methods for connecting the computer to the RSS-10. One is via MIDI and the other
is through the Serial Port.
To connect via MIDI, you must prepare the specific interface for the computer you use. To connect
through the Serial Port, you need a connection cable.
Connection cables are optionally available: RSC-15AT {IBM compatible), RSC-15N (NEC), and
RSC-15APL (Macintosh).
Basic Operationai Test
1. when you have finished all the necessary connections, turn down the volume of the amplifier then
switch on the units.
2.
Install the supplied application and re-boot the system.
3.
Some sample files are stored on the supplied disk. Open one of them.
4.
Using the application, get the MIDI Indicator on the RSS-10 to start flashing.
5.
Adjust the volume of the amplifier, then follow the owner's manual of the application.
29