Roland RSS-10 - Manual (Page 23)

CONTROLUNG THE THREE-DIMENSIONAL SOUNDS USING THE MCR-8
The parameters that control three-dimensional sounds correspond to the knobs/slidersAtuttons on the MCR-8 as follows.
Please move the knob/sliderA>utton that corresponds to the parameter you wish to control.
Aztfrmh*C»eg^
o o
,
_____ В______ _
Azirruti Pigino
о б
________ Reverb_______ _
WiiCdci Flavor -
O O O
ReflBcton
О
RoorCohv
0
DiiBdOn — a □ KiedOn — □ □ □ □ □ ABS □
DireaOi! - □ □
Oist
DiredOR □ □
Diet Eiev
О D □
Uvol Size TliTW
REL П
RoorOiststci
HMCbhwflS
Оъйри!
0=0
и Lp p=p
= — I
=
—
— n n
1
-
Setting the Position of the Sound Source
The position of the sound source can be set with the directions and distance. The STATIONARY Mode allows you to set
two positions A and B separately, while the FLYING Mode allows only channel A.
1 -1 Dist (Distance) (the distance to the sound source)
This sets the distance from the ear position to the sound source. The changes in the distance that
occur as a result of the fader's movement are predetermined.
1 >2 Elev (Elevation) (the upper and lower directions of the sound source)
This sets the upper and lower directions (180° vertically) from the ear position to the sound source.
1 -3 Azimuth (Azimuth) (horizontal directions of the sound source)
This sets the horizontal directions (360° horizontally) from the ear position to the sound source.
1 -4 Direct On/Off (Direct On/Off) (On/Off of the direct sound, including the floor reflection)
This turns on or off the direct sound, including the floor reflection, but leaves the reverberation
unaffected.
1 -5 Clipping (Clipping Area)
Theoretically speaking, as the sound source is moved closer to your ears, the sound will be
infinitively louder. This, however, is impossible in reality. The volume is set so there is a limit,
beyond which it will not become higher even though the sound source has become closer. The area
with a radius at this distance is called the Clipping Area. A shorter radius will make the volume of
the sound much smaller even by removing the sound source only slightly from your ears. If most
sounds are at a distance, the overall volume may be too low. If this happens, you must make the
Clipping Area larger.
1-6 Level (Reverb Level)
This sets the ratio of the reverberation to the direct sound. Normally, set the fader to its maximum
or slightly lower than that.
23