Adjusting the input level, Q roland, Note – Roland RSS-10 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING THE INPUT LEVEL
Feed a signal into the RSS-10, then set the Input Level Knobs so that "OVER" in the Input Level Indicators and the Output
Level Indicators are just short of lighting. The Input Level Knobs allow you to control the right and left channels
independently.
Q Roland
O
Omrirr LEVEL
i
(Ml -«B -ao >44 -M -33 -34 -30 -14 -10 -« -30VER (40) -10 -«OVER
The Input Level Indicators indicate the input level of the internal processor and can be adjusted
using the Input Level Knobs. The Output Level Indicators indicate the output level of the internal
processor. The output level will differ depending on the directions of the sound sources, or the depth
of the reverb effect, so you must be careful about the input level adjustment.
16