Futaba 12Z User Manual

Page 16

Adjustment of the stick lever length

OLNH,WLVUHFRPPHQGHGWRDGMXVWWKHOHQJWKRIWKH
sticks in line with your hand size.

Lever Head

1. Hold the lever head "B" and turn the lever

head "A" counter-clockwise, the lock will be
released.

2. Turn the lever-head "A" clockwise as you hold

the lever-head "B" after placing it as you like.

Adjustment of stick lever tension

The tension of the self-return type stick lever can

EHDGMXVWHG

1. Remove the rubber grip on the back of the

transmitter.

Ɣ6WLFN

7HQVLRQ

(J1)

0RGH

Ɣ6WLFN7HQVLRQ-)
0RGH

Ɣ6WLFN7HQVLRQ-4)
0RGH

Ɣ6WLFN7HQVLRQ-3)
0RGH

2. Use the accessory 1.5mm hexagonal wrench

to adjust the spring strength as you prefer by
turning the adjusting screw of the stick you
want to adjust.

*Turning the screw clockwise increases the tension.

3) At the end of adjustment, re-install the

rubber grip.

Adjustment of Throttle Stick (Ratchet System)

You can also choose either airplane ratchet

system or helicopter-touch.

Ɣ5HWDLQLQJ)RUFH-
0RGH

Ɣ5HWDLQLQJ

)RUFH-

0RGH

1. Open the dust protection cap on the back

of the transmitter that is covering the hole for
throttle stick adjustment.

2. Use the attached 1.5mm hexagonal wrench

to turn the adjustment screw and set it as you
prefer. Turning the screw clockwise increases
the tension.

Hole for throttle

stick adjustment

For airplane (Mode1)
For helicopter (Mode2)

For helicopter (Mode1)
For airplane (Mode2)

*This transmitter has two ratchet plates, one for airplane

and the other one for helicopter. If you tighten both screws,
\RXZRQWEHDEOHWRDFKLHYHWKHDGMXVWPHQWWKDW\RXQHHG
EHFDXVHRIWKHRYHUODSRIWKRVHWZRDGMXVWPHQWV

*If you want to change the setting from airplane to helicopter

(or from helicopter to airplane), turn counterclockwise until
the throttle stick moves freely. Then turn the screw for the
helicopter (or airplane) until you get the tension you like.