Futaba 12Z - Manual (Page 120)

120
Common operations used in function setup screen
This section describes the functions often used at the function setup screen. Refer to it when setting each
function.
Group/single mode switching (GROUP/SINGLE)
When setting multiple flight conditions,
linking the setting contents with other conditions
(group mode) or setting independently (single
mode) can be selected. The mode can be
changed at the [GROUP] item on each setup
screen.
[Group/single mode switching]
1. Use the cursor lever to move the cursor
(reverse-video) to the [GROUP] item on
the setup screen.
2. Turn the data input dial to the left until
switch [SINGLE] starts to blink.
*At this point, the mode has still not been changed.
*When changing from [SINGLE] to [GROUP], turn the
data input dial to the right.
3. Change the mode by pushing the enter
key.
ŏ*URXSPRGH*5283,QLWLDOVHWWLQJ
The same setting contents are set to all
WKHÁLJKWFRQGLWLRQVLQWKHJURXSPRGH
ŏ6LQJOHPRGH6,1*/(
Set this mode when the setting contents
are not linked with other conditions.
ŏ 6 H O H F W L Q J W K H V L Q J O H P R G H D W H D F K
condition after presetting in the group
mode is convenient.
Condition delay setting
Unnecessary fuselage motion generated when
there are sudden changes in the servo position
and variations in the operating time between
channels can be suppressed by using the
condition delay function of the condition select
function [CONIT. SELECT].
W h e n t h e d e l a y f u n c t i o n i s s e t a t t h e
switching destination condition, a delay
corresponding to that amount is applied and the
related functions change smoothly.
[Setting method]
*At the condition delay setup screen,
m o v e t h e c u r s o r ( b l i n k i n g ) t o t h e
[DELAY] item of the channel you want
to set and perform the following settings:
1. Switch to the condition you want to set.
2. Set the delay.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
(When the enter button is pushed for 1 second, the delay is
reset to the initial value.)
2SHUDWLRQVUHODWHGWRÀLJKWFRQGLWLRQV
2SHUDWLRQVUHODWHGWR¿QHWXQLQJ95
ŏ95VHOHFWLRQ ŏ5DWHDGMXVWPHQW
(Fine tuning VR operation position)
ŏ2SHUDWLRQPRGHVHOHFWLRQ
*The operation modes which can be
selected depend on the function.
*When the mode is displayed by an
icon, read the description at the
right.
[Operation mode]
0L[LQJ UDWH DW FHQWHU RI 95 :KHQ WKH 95 LV
turned clockwise and counterclockwise, the mixing
rate increases and decreases, respectively.
0L[LQJ UDWH DW OHIW HQG RI 95 :KHQ WKH 95 LV
turned, the mixing rate increases.
0L[LQJ UDWH DW ULJKW HQG RI 95 :KHQ WKH 95 LV
turned, the mixing rate increases.
:KHQ WKH 95 LV WXUQHG WR WKH OHIW RU ULJKW RI WKH
neutral position, the mixing rate increases.