FloAire STAGED ELECTRIC HEAT MODULE - Manual (Page 24)

24
Start-Up and Maintenance Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN
AIR BALANCED AND WITH THE HEAT ON. (Warranty will be void without completion of this form)
Job Information
Job Name Service Company
Address Address
City City
State State
Zip Zip
Phone Number Phone Number
Fax Number Fax Number
Contact Contact
Purchase Date Start-Up Date
Heater Information
Refer to the start-up procedure in this manual to complete this section.
Name Plate and Unit Information
Field Measured Information
Model Number Coil Voltage
Serial Number Coil Amperage
Coil Voltage Motor Voltage
Coil Hertz Motor Amperage**
Coil Phase RPM
Coil FLA Thermostat Set-Point
# of Steps Temperature Control Discharge
Motor Volts Space
Motor Hertz # of Operating Steps
Motor Phase
Motor FLA Airflow Direction Correct
Motor HP Incorrect
Blower Pulley
Motor Pulley
Belt Number
** If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced to decrease the
measured amps below the nameplate FLA rating.
Maintenance Record
Date Service Performed
Factory Service Department
Phone: 1-866-784-6900
Fax: 1-919-554-9374