Ingress online activation, Installation and setup of ingress, Power supply port – FingerTec R2 Manual User Manual
Page 13: Access control port, Bell port
JOINT 1 PIN
JOINT 2 PIN
TX+ 1
• •
3 RX+
TX-
2
• •
6 RX-
RX+
3
• •
1 TX+
RX-
6
• •
2 TX-
CONNECTOR PIN
CABLE COLOR
CONNECTOR
TX+ 1
•
White/Orange
•
1
TX+
TX- 2
•
Orange
•
2
TX-
RX+ 3
•
White/Green
•
3 RX+
4
•
Blue
•
4
5
•
White/Blue
•
5
RX- 6
•
Green
•
6 RX-
7
•
White/Brown
•
7
8
•
Brown
•
8
NOTE
Link all cables to the correct connection point(s)
before attempting to connect the terminals to
software.
TCP/IP for Network Connection
–
Linking
the terminals to multiple computers using TCP/
IP requires Ethernet 10/100Base-T Straight Thru
Cable or “whips”. The cable works with both
10Base-T and 100Base-TX, connecting a network
interface card to a hub or network outlet.
POWER SUPPLY PORT
Insert the Power Adapter point to this port for power.
RS232/RS485/WIEGAND CONNECTION PORT
RS232
–
Connection to a computer using RS232 cable.
RS485 Single Connection
-
Connection to a single computer using RS485 wire.
RS485 Network Connection
-
Connection to multiple computers using Daisy Chain connection.
Wiegand Output
–
Connecting with third party connector or terminal(s).
ACCESS CONTROL PORT
Linking the terminal to door lock system.
BELL PORT
Linking the terminal to doorbell.
Ingress Online Activation
Ingress is a genuine software by FingerTec. Every FingerTec access control model comes
bundled with a unique license key. To start using the terminal with Ingress, you must
connect the terminal to Ingress and perform online activation. Ingress reads the serial
number of your terminal and sends it for verification at the FingerTec server via Internet.
In case you do not have an Internet connection, you would need to do offline activation.
Please send the serial number and models of your terminals to your local resellers or
sup-
to request for a product key and activation key.
Installation and Setup of Ingress
Install Ingress in a PC that fulifills Ingress’ minimum requirements. Refer to
http://www.
fingertec.com/customer/download/postsales/SUM-Ingress-E.pdf
for the Ingress user
guide online. Setup Wizard will require you to do online activation before connection
establish between Ingress and terminals.