Cradlepoint MBR1400LE - Manual (Page 97)

CRADLEPOINT
MBR1400| USER MANUAL Firmware ver. 3.4.1
© 2012 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 95
7.1 Connection Manager
The router can establish an uplink via the Ethernet WAN port, WiFi as WAN, or modems plugged into a modem port. If the
primary WAN connection fails the router will automatically attempt to bring up a new link on another device. This feature is
called failover. If Load Balance is enabled, multiple WAN devices may be plugged in and each may establish a link.
7.1.1 WAN Interfaces
This is a list of the available interfaces used to
access the Internet. You can enable, stop, or start
devices from this section. By using the priority
arrows (the arrows in the boxes to the left
—these
show if you have more than one available
interface), you can set the interface the router uses
by default and the order that it allows failover.
In the example shown, Ethernet is set as the primary Internet source, while an ExpressCard modem is attached for
failover
. The Ethernet is ―Connected‖ while the modem is ―Available.‖
Load Balance: If this is enabled, the router will use multiple WAN interfaces to increase the data transfer throughput by
using any connected WAN interface consecutively. Selecting Load Balance will automatically start the WAN interface and
add it to the pool of WAN interfaces to use for data transfer. Turning off Load Balance for an active WAN interface may
require the user to restart any current browsing session.
Enabled: Selected by default. Deselect to disable an interface.
Click on a device in the list to reveal additional information about that device and to enable configuration options.