Eliminator Lighting Electro Disc LED User Manual
Page 4
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Controls and Functions:
1. Black Out - This button will black out the unit.
2. Select Prog - This button will allow you to access the
auto run mode and built in programs. Each press of the but-
ton will change to the next mode.
3. Flash - This button will activate the strobe function. Use
the “+” & “-” buttons to adjust the strobe speed.
4. SPEED - Press this button to activate and use the “+” &
“-” buttons to adjust the speed of the color fade mode and
color change mode.
5. DMX Mode - Activates DMX Mode.
6. Set Addr - Press this button to set the DMX address.
Press this button first, then press the numbers to set the
address.
Example: Set DMX Address 1 Press “S-0-0-1”
Set DMX Address 245 Press “S-2-4-5”
7. SL/SA (Slave/Sound Active) - This button lets you
switch between Slave mode in a Master-Slave configuration
and Sound Active mode. When the fixture is in Sound Active
mode, use the “+” & “-” buttons to adjust the sound sensitiv-
ity.
8. R G B A W - Press either one of these buttons and the
press the “+” or “-” to adjust the brightness. Press the Flash
Button to activate strobing and use the “+” & “-” buttons to
adjust the strobe speed. The “A” & “W” buttons will not work
with this unit.
9. “+” and “-” - Use these buttons to adjust the flash rate
speed, program speed, sound sensitivity, and program se-
lection.