Eliminator Lighting E-109 User Manual

E 109

E 109

SPECIFICATIONS:

Model:

E 109

Lamp:

2 x LL-64514 120V 300W

Weight:

7 lbs.

Size:

14” x 12” x 12”W

Fuse:

10 Amp

Supply Voltage:

120V

Working Position:

Any Safe position

Duty Cycle:

10 min. on,10 min. off

Colors:

Multiple Colored Lenses

Warranty:

1 Year Limited Warranty

CAUTION! Please read and
understand these instructions
before installing or operating
this unit.

Operating Instructions:
The E 109 is a powerful effect for clubs and dj’s. The
E 109 creates a dramatic cluster of 30 multi-colored
beams. This unit features an internal microphone
that allows the beams to be triggered by sound. The
E 109’s beams bounce up and down to the beat of
the music. The E 109 is ready to be hung or set on
the ground in a safe position. When mounting this
unit to truss be sure to use a clamp. Plug the unit in
to a standard 110 wall outlet. After plugging the unit
in, the fixture will react to the beat of the music via
the sound active internal microphone. The unit has
a sensitivity knob on the rear of the unit that makes
more or less sensitive to sound. Turing the knob in
clockwise direction will make the unit more sensitive
to sound. The unit requires sound to activate the
movement.
Lamp Replacement: Disconnect the units main
power supply. Unscrew and remove the thumb
screws on the front of the fixture. Remove and
replace the bulbs. Reassemble and reconnect the
power supply. Be sure to follow all the handling
instruction that are included with your new lamp.

HALOGEN LAMP WARNING!

This fixture is fitted with halogen
lamps which are highly susceptible
to damage if improperly handled.
Never touch lamp with bare fingers
as the oil from your hands will short-
en lamp life. Also, never move fixture
until lamp has had ample time to
cool. Remember, lamps are not cov-
ered under warranty conditions.

Caution! Never open unit when in use.
Always disconnect main power before
serving or replacing lamp. Remember to
always replace with the exact same type
lamp and fuse.