Eliminator Lighting LED Cloud - Manual

CAUTION! Please read and under-
stand these instructions before
installing or operating this unit.
Operating Instructions:
This unit is a 4 channel DMX intelligent LED unit. It can be run as a stand-alone or in a master-slave
configuration. The unit has 3 operating modes; sound active mode, auto mode or DMX controlled.
This unit has been tested at the factory, there is no assembly required. The unit is ready to be
plugged in to a power outlet. To run the different operating modes, see the next page. To enhance
the beams use this effect with a fog machine.
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Caution! Never open unit when in use.
Always disconnect main power before
servcing. Remember to always replace
with the exact same type fuse.
LED Cloud SPECIFICATIONS:
Model: LED Cloud
Supply Voltage: 100V ~ 240V 60Hz/50Hz
LEDs: 5 x 3W LEDs
Power Consumption: 27.5W
Weight: 4.4lbs./ 2kgs.
Size: 9.8” (L) x 7” (W) x 9.5” (H)
Fuse: 3 Amp
Working Position: Any Safe position
Duty Cycle: None
DMX Channels: 4
Colors: RGBWA
Warranty: 1 Year
Fuse Replacement: Locate and remove the unit’s power cord. Once the cord has been removed
located the fuse holder located inside the power socket. Insert a flat-head screw driver into the power
socket and gently pry out the fuse holder. Remove the bad fuse and replace with a new one. The fuse
holder has a built-in socket for a spare fuse be sure not to confuse the spare fuse with active fuse.