Eliminator Lighting Mini Spot LED User Manual

Mini spot led

MINI SPOT LED

SPECIFICATIONS:

Model: Mini Spot LED

Supply Voltage: 120V/60Hz

LED:

1 x 3W White LED

Power Consumption: 5W

Beam Angle:

9 Degrees (Standard)

Degrees

(Included)

Weight:

0.92 lbs./ 0.42 kgs.

Size:

3.81” L x 3.5” W x 5.3” H

Working Position: Any Safe position

Duty Cycle:

None

Warranty:

1 Year

CAUTION! Please read and understand these instructions before installing or

operating this unit.

Introduction and Operation: The unit is ready to be hung or set on flat surface. This fixture is designed to

operate as a stand alone unit. It has been tested at the factory and there is no assembly necessary. The Mini

Spot LED is a small LED pin spot. Plug this fixture in and it will light right up.The unit comes equipped with 9

degree lens, with a 12 degree lens included. To change the lens, remove the fixture ring that holds the current

lens in place, then remove the lens and replace with the other lens. Place the fixture ring back into its place to

hold the new lens in place.

1 Year Limited Warranty:

Eliminator Lighting warranty is valid from the date of purchase. Our

1 year limited warranty covers manufacturing defects only. Serial number, place of purchase with

dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover

items or parts prone to wear and tear: lamps, fuses, brushes and belts. Eliminator Lighting warranty

is only valid with-in the United States.