Eliminator Lighting UV Disc User Manual

Uv disc, Specifications

UV Disc

SPECIFICATIONS:

Model: UV Disc

Voltage:

100V-240V 50/60Hz

LEDs:

9 x 1Watt UV LEDs

Beam Angle:

60 Degrees

Power Consumption:

20W

Weight:

4lbs./ 1.75kgs.

Size:

11.25”(L) x 9.5”(W) x

3.25”(H)

Fuse:

Amp

Power Cord Daisy Chain: 31 Fixtures Max.

Working Position:

Any Safe position

Duty Cycle:

None

DMX Channels:

1 DMX Channel

Colors:

Warranty:

1 Year

CAUTION! Please read and under-

stand these instructions before

installing or operating this unit.

Operating Instructions:

The UV Disc has been tested at the factory, there is no assembly required. The unit is ready to be

plugged into a power outlet. This unit is a 1 channel DMX intelligent UV LED wash. It has 2 operating

mode; Manual mode or DMX mode. The UV Disc can be used as a stand alone unit or in a master-

slave configuration.
Fuse Replacement: Disconnect the unit from its power source. Remove the power cord from the

unit. Once the cord has been removed, you will find that the fuse holder is located inside the power

socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.

Remove the bad fuse and replace with a new one. The fuse holder also has a holder for a spare fuse.

Power Cord Daisy Chaining: With this feature you can connect the fixtures to one another using the

IEC input and output sockets. The quantity that can be connected is 31 fixtures maximum. After 31

fixtures you will need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures.

Caution! Never open unit when in use. Always

disconnect main power before replacing fuse.

Remember to always replace with the exact same

type fuse.