Eliminator Lighting Aqua LED User Manual

Aqua led

AQUA LED

SPECIFICATIONS:

Model: Aqua LED

Supply Voltage:

120V/60Hz

LED:

1 x 10W LED

Power Consumption: 12W

Fuse:

1Amp

Weight:

6 lbs./ 2.7 kgs.

Size:

8” L x 9” W x 9” H

Beam Angle:

Working Position:

Any Safe position

Duty Cycle:

None

Warranty:

1 Year

CAUTION! Please read and understand

these instructions before installing or oper-

ating this unit.

Introduction and Operation: The unit is ready to be hung or set on flat surface. This fixture is

designed to operate as a stand alone unit. It has been tested at the factory and there is no assem-

bly necessary. The Aqua LED is a rippling water effect. Plug this fixture in and it will light right up.

On the rear of the unit there is a toggle switch that is used to control the internal color wheel. When

toggle switch is one position the color wheel will automatically and continuously scroll through the

color wheel. When the color wheel toggle switch is in the opposite position the color wheel will lock

in place. You can create a more dramatic effect by using split color combinations by stopping the

wheel anywhere between two adjacent colors.

1 Year Limited Warranty:

Eliminator Lighting warranty is valid from the date of purchase. Our

1 year limited warranty covers manufacturing defects only. Serial number, place of purchase with

dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover

items or parts prone to wear and tear: lamps, fuses, brushes and belts. Eliminator Lighting warranty

is only valid with-in the United States.

Caution! Never open unit when in use.

Always disconnect main power before

replacing the fuse. Remember to always

replace with the exact same type of fuse.

Fuse Replacement: Locate and remove the unit’s power cord. Once the cord has been removed

located the fuse holder located inside the power socket. Insert a flat-head screw driver into the power

socket and gently pry out the fuse holder. Remove the bad fuse and replace with a new one. The fuse

holder has a built-in socket for a spare fuse be sure not to confuse the spare fuse with active fuse.