Eliminator Lighting Electro Disc LED - Manual (Page 3)

DMX Mode:
O perating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Electro Disc LED has 4 DMX channels. See the chart below for the
DMX traits and values.
1. This function will allow you to control each individual fixture’s traits with a standard DMX 512
controller.
2. To run your fixture in DMX mode press the MODE button until “d.XXX” is displayed. “XXX” repre
sents the current displayed address. Use the UP or DOWN buttons to select your desired DMX
address.
3. After you have chosen your desired DMX address plug in the fixture via the XLR connections to
any standard DMX controller.
Master-Slave Configuration:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the first “Slave” unit to the “Master.”
3. Set the “Master” unit to your desired mode of operation. On the “Slave” unit, press the MODE
button until “Slau” is displayed. The “Slave” unit will now follow the “Master”.
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
CHANNEL VALUE FUNCTION
CH1 000-255 Red(dim bright)
CH2 000-255 Green(dim bright)
CH3 000-255 Blue(dim bright)
CH4
000-189 Dimmer(dim bright)
190-250 Flash(slow quick)
251-255 No function
DMX Traits
Photometric Chart