ConvertiBARS Triumph: Sprint RS (99-02) - Manual

Triumph Sprint RS (99-02)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.
Restrictions
1. Fairing side pieces or intake ducts interfere with the riser when rotating the
Cyclops Clamps. Raising the handlebar so the riser is above the fairing side
pieces before rotating the Cyclops clamps will solve this restriction. Trimming
the fairing side pieces could also increase convertibility.
Line Routing
1. Throttle lines - Stock Length - Route below the brake lever
Recommended Riser Trim Length
1. 6.5" Riser Length = Trim Number 11
Recommended parts and replacement lines
1. Hydraulic Brake Line Top Fitting - 90 degree face to the side
2. Hydraulic Brake Line = Stock + 5"
3. Throttle Lines - Stock + 2"