ConvertiBARS Kawasaki: ZX-9R (98+) - Manual

Kawasaki ZX-9R (98+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Fairing stay restricts rise to less than one inch. If modified and a longer brake
line is added, much more rise could be achieved.
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
Restrictions
1. Fairing stay/windshield Frame - restricts rise. If the fiaring stay is modified or
removed, more rise can be achieved.
Line Routing
1. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the
rider's side of the forks
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and replacement lines
1. Hydraulic Brake Line = Stock + 3"
2. Hydraulic Clutch Line Top Fitting - 90 degree face to the side