ConvertiBARS Ducati: Monster(2002+) - Manual

Ducati Monster(2002+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Simple Install. Re-routing of the wires and lines is necessary and some
individual ingenuity is required, but the install is relatively simple and straight
foreword. Monsters made before 2002 however, have a taper on the fork tube
that makes it impossible to mount a clip-on style handlebar to.
Recommended Riser Trim Length
1. 8.0" Riser Length = No Trimming
Recommended parts and replacement lines
1. Hydraulic Brake Line - OK
2. Throttle Lines - Ok rerouted
3. Cable Clutch Line - Ok rerouted