ConvertiBARS Honda: CBR-600RR (03 only) - Manual

Honda CBR-600RR (03 only)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Stock brake resevoir is too large and is in a fixed location. Replace master
cylinder with one from a 900RR. You will also need to lengthen the clutch cable
by contacting Motion Pro.
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
Restrictions
1. Kit works well as a riser, but there are restrictions when converting to a lower
handlebar position.
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and replacement lines
1. Hydraulic Brake Line = Stock + 3"
2. Cable Clutch Line - Stock + 2"