ConvertiBARS Aprilia: SL1000 Falco - Manual

Aprilia SL1000 Falco
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Some stock cables need to be sent to Motion Pro for lengthening.(7-12 day turn
around) Kits works well as a riser. There are some positioning restrictions when
lowing the bars.
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
Restrictions
1. Upper fairing and or windshield can be trimmed for more rise.
2. Kit works well as a riser, but there are restrictions when converting to a lower
handlebar position.
Recommended Riser Trim Length
1. 6.5" Riser Length = Trim Number 11
Recommended parts and replacement lines
1. Hydraulic Brake Line Top Fitting - 90 degree face down
2. Hydraulic Brake Line = Stock + 3"
3. Throttle Lines - Ok rerouted
4. Throttle Advance/Choke Cable needs to be rotated, rerouted and or
lengthened (stock+2") see photo
5. Longer lines than stated here may be required if raising the bars more than the
recommended trim length.
6. Hydraulic Clutch Line = Ok
Bars Up Throttle Advance Position