ConvertiBARS Aprilia: Futura - Manual

Aprilia Futura
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Works well as a riser, however, fairing and triple clamp pinch bolts restrict
convertibility. Hydraulic lines top fittings need approx 30 degree bend. Riser
pipe will need to be trimmed to desired rise. some models will require raising
fork tube up approximatley 10-15mm.
Special Kit Requirements/Installation Tips
1. Cyclops Clamps - are to be mounted on top of the triple clamp
Restrictions
1. Foreword Positions restricted by instrument panel
2. Kit works well as a riser, but there are restrictions when converting to a lower
handlebar position.
Recommended Riser Trim Length
1. 8.0" Riser Length = No Trimming
Recommended parts and replacement lines
1. Hydraulic Brake Line = Stock + 3"
2. Hydraulic Clutch Line = Stock + 2"