ConvertiBARS Honda: CBR-1100XX Blackbird(97+) - Manual

Honda CBR-1100XX Blackbird(97+)
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Special dual brake line works with linked braking system. Remove the top line(2
lines with a junction block)and the hard cross over line. The replacement lines
Both bolt at the master cylinder using a double banjo bolt and 3 washers. On
the opposite ends, the line with the male threaded end, attaches to the clutch
side crossover block. The second line attaches directly to the right caliper.
Convertibility is restricted by fairing side pieces.
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.
3. Cyclops Clamps - are to be mounted on top of the triple clamp
Restrictions
1. Foreword Positions restricted by instrument panel
Line Routing
1. Throttle Lines - Stock length - route behind the right fork tube
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8
Recommended parts and replacement lines
1. Hydraulic Brake Line = Stock + 3"