ConvertiBARS Suzuki: TL1000R - Manual

Suzuki TL1000R
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.
3. Trimming - Depending on handlebar position, the upper fairing and or
windshield may need to be trimmed for clearance. Marking the line with tape
and using a dremel tool for trimming is recommended.
4. Fairing spacer pack recommended to lift the fairing for more rise.
Restrictions
1. Fairing stay/windshield Frame - restricts rise. If the fiaring stay is modified or
removed, more rise can be achieved.
Recommended Riser Trim Length
1. 5.0" Riser Length = Trim Number 8