ConvertiBARS Suzuki: SV650S(ABS) 07+ - Manual

Suzuki SV650S(ABS) 07+
Bike Specific Install Notes and Tips
This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to
set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike
Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with
out pulling taught or kinking any lines, and without damaging any part of the motorcycle
Important Installation Considerations
Special Kit Requirements/Installation Tips
1. Contact - Slight fairing contact is ok as long as the steering stops can be
reached with out damaging the fairing
2. Zip ties or brackets holding excess electrical lines will need to be cut or removed
to free up extra length.
3. Moving - Moving the clutch lever, and brake lever toward the center of the
motorcycle will allow greater upper fairing/windshield clearance
Line Routing
1. All longer lines routed as stock.
2. Clutch Line - Stock Length - Route behind fork tube
Recommended Riser Trim Length
1. 6.5" Riser Length = Trim Number 11
Recommended parts and replacement lines
1. Suzuki SV-650S(03+) Stock+50mm length Clutch Line. Part Number 07-0803.
Order from ConvertiBARS.
2. Suzuki SV-650S & SV-1000S(03+) Stock+75mm length Throttle Lines. Part
Number 07-0802. Order from ConvertiBARS
3. Hydraulic Brake Line Top Fitting - 90 degree face to the side
4. Hydraulic Brake Line = Stock + 4"
5. Throttle Lines - Stock + 2"
6. Cable Clutch Line - Ok rerouted
7. Cable Clutch Line - Stock + 2"