Comtrol Modbus TCP User Guide User Manual

Page 98

98 - Appendix A. Programming the PLC via Concept

DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I

Setting up and Running the Concept Example Programs

Select OK.

16. In the PLC Memory Partition pane:

Verify that your PLC has sufficient memory. The example program requires 3000 holding registers.

Select OK.

17. In the Config Extensions->Ethernet/ IO Scanner pane:

Select your method of specifying an IP address.

If you are specifying an IP Address:

•

Enter the PLC IP Address under Internet Address.

•

Enter the Gateway address.

•

Enter the Subnet Mask.

Verify the Master Module is configured properly.