Serial port, Configuration properties, Serial device configuration page – Comtrol Modbus TCP User Guide User Manual
Page 35

DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I
Chapter 3. Embedded Configuration Pages- 35
Serial Device Configuration Page
3.3. Serial Device Configuration Page
The Serial Device Configuration page provides:
•
Links to other pages
•
Access to the Edit Serial Port Configuration page for each port (Port #)
•
An overview of serial device configuration settings for each port displays the current settings
To change these settings for a port,
select the corresponding Port # link,
which opens the Edit Serial Port
Configuration page. See
Serial Port Configuration Page
Page 35 to locate information for
each setting area.
3.3.1. Edit Serial Port Configuration Page
Use the Edit Serial Port Configuration page to change a serial port’s configuration parameters.
To access the Edit Serial Port Configuration page, select the appropriate port number link (for example, Port
1) on the Serial Device Configuration page.
The next two subsections discuss the Serial Port and Serial Port Packet ID Settings areas on this page. The
remainder of the page is discussed in the following subsections, which are located under the 3.6. Common
Configuration Areas (Serial or Ethernet Device) section:
•
3.6.3. Filtering/Data Extraction Configuration
•
3.6.4. Application TCP Connection Configuration
•
PLC Interface
Diagnostics
Opens the PLC Interface Diagnostics page (
4.2. PLC Interface Diagnostics
68), which contains the statistics and error reporting for the Modbus/TCP PLC
interface.
Display All Modbus
Slave Devices
Opens the Known Modbus Slave Device List page (Page 71), which contains statistics
for the automatically located serial Modbus devices and configured remote Modbus
devices.
Display Serial Logs
Opens the Serial Interface Logs page (Page 73), which provides access to the receive
and transmit serial logs.
Display Ethernet
Device Logs
Opens the Ethernet Device Interface Logs page (Page 74), which provides access to the
receive and transmit logs.
Configure Network
Opens the Configure Network page (
3.7. Edit Network Configuration Page
57), which can be used to modify DeviceMaster UP network configuration after initial
configuration using PortVision DX.
Configure Security
Opens the Edit Security Configuration page (
3.8. Edit Security Configuration Page
Page 58), which provides security configuration functionality for the DeviceMaster
UP.
Reboot
Reboots the DeviceMaster UP.
Server Configuration Page