Toshiba IK-TU40A User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

(4.3)

Changing black gamma correction level

® Set the to BLACK GAMMA by pushing [MENU UP], [MENU DOWN] buttons.

[DATA UP]

low

!S:

norm

high

;

[DATA DOWN]

(When OFF is selected in GAMMA ON/OFF selection line, the display GAMMA

turns off automatically. So the gamma correction level change cannot be changed.)

(4.4) Changing two-dimension low pass filter

® Set the to 2D LPF by pushing [MENU UP], [MENU DOWN] buttons.

@ Select either ON or OFF by pushing [DATA UP], [DATA DOWN] buttons.

When ON is selected, the cross color noise in VBS output is reduced.

Note:

Select OFF in step 2 described above when using signals other than the

VBS output.

When OFF is selected in the GAMMA ON/OFF line or when DTL OUT ON

is selected in the OPTION menu, the display 2D LPF turns off automati

cally. So 2D LPF change cannot be performed. (2D LPF is set to OFF.)

(4.5) Changing detail (outline) gain

® Set the to DTL GAIN by pushing [MENU UP], [MENU DOWN] buttons.

Set the detail gain by pushing [DATA UP], [DATA DOWN] buttons.

(DTL OFF)

■^The detail increases by pushing [DATA UP].

-> 00 <-------- > 5

■ The detail decreases by pushing [DATA DOWN].

(When DTL OUT ON is selected in OPTION menu, the display DTL GAIN turns off
automatically. So DTL GAIN change cannot be performed.)

(4.6)

Changing detail boost frequency

® Set the to DTL B.FREQ by pushing [MENU UP], [MENU DOWN] buttons.

Set the detail boost frequency by pushing [DATA UP], [DATA DOWN] buttons.

[DATA UP]

low

norm

high

;

[DATA DOWN]