Toshiba TEC MA-1060-100 Series - Manual (Page 63)

ADDRESS NO. - CONTENTS Standard Bit Set
%
VALIDATION COMPULSORY I
L L 1 1 1 1 1 l°l
BIT
NO.
ITEM SELECTIVE STATUS
STANDARD
STATUS
REMARKS
1
RESET FREE
1RTN MDSE 1 Key
SET COMPULSORY
2 iPOl Key
RESET FREE
X-
SET COMPULSORY
3
RESET FREE
*
IK/A| Key
SET COMPULSORY
k
Q
RESET FREE
*
11ItM CORN 1 Kev
SET COMPULSORY
5
g
RESET FREE
*
IVUIUI Kev
SET COMPULSORY
g
New Balance in
Post Charging RESET FREE
*
SET COMPULSORY
7
RESET
.
SET
S
—vacant
RESET
SET
NOTE: If status "COMPULSORY" is selected, the "SLIP" lamp will flash after operating the key,
and thereafter no other operation except validation printing will be allowed. This status
will be effective in the "REG" and "MGR" modes only. In the " [^1 n mode, validation print­
ing may be performed freely (not compulsory) after any function key regardless of the
FEE/COMPULSORY status selected for each key in the above table.
Q; The selection of Bit No.A will also be applied to the IIC/VDI key when it is used as the
ITEM CORRECT key.
The selection of Bit No. 5 will also be applied to the IIC/VOI key when it is used as the
VOID key.
- 59 -