Toshiba TEC MA-1060-100 Series User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/671426/15/background.png)
PERCENT CHARGE KEY
This key is used to add a percentage rate to a sale. If the pre
programmed
percentage
rate
is
to
be
added,
depress
the
[HI
key
without a prior numeric entry. If a rate different from the pre
programmed
%
rate is to be added, enter the desired rate on the
numeric'" keyboard and then depress the
\ % ^ ■
I
key. (The manual rate
will take priority.)
To operate, depress the
\ % + \
key either immediately after a depart
ment entry if only that item requires the percentage addition, or
after the FST i key if required on the total bill. The percentage
rate and the amount are printed and will be added to the sale total.
The percentage rate may be within the range from 0.001 to 99*999^*
The fraction resulted from the percentage calculation is usually
programmed to rounded off. However, it can be programmed to be
rounded up or discarded.
Usually, if the
\ % + \
key is depressed after a second [sfl key
depression within a sale, it adds the rate to the entire sale total.
However, it can be programmed to add the rate to the subtotal of the
items entered between the first and the second 1 ST| key depressions.
PERCENT DISCOUNT KEY
This key operates in the same fashion as the
El
key except that
operation will subtract from instead of adding to a sale.
[C]
CLEAR KEY
This key is used to correct a numeric entry error prior to depressing
any other key, or to correct any error condition and cancel the alarm
buzzer.
If the
key is depressed after a sub-total is obtained, the sub
total is again displayed.
ITX/MI (for Single-tax Area)
|TXr/M|, 1TX2/MI (for Dual-tax Area)
TAX MODIFIER KEYS
Each of these keys is used to reverse the taxable/non-taxable status
on departments other tax-programmable keys for one entry only. For
dual-tax areas, two keys should be provided — jTX1/M| and ITX2/M[
— in place of the
I
TX/M
I
key for the single-tax areas. The two tax
modifier keys will function independently each with its own tax table
pre-programmed for taxable items.
The tax modifier key(s) will be effective to reverse the tax status
programmed on Department keys, jPOLL DISCl,
IBTL RTN!,
and PLUs.
T
o
operate, depress the 1TX/M| key prior to depressing any of these
function keys above listed, i.e., either before or after the amount
entry.
- 11 -