Toshiba 32HLX95 - Manual (Page 67)

Chapter 8: Using the TV’s features
Scrolling the TheaterWide® picture
(TheaterWide 2 and 3 only)
You can set separate scroll settings for TheaterWide 2 and
TheaterWide 3 modes for each input.
To set the scroll settings:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
s Picture Settings
Advanced Picture Settings
(#) Navigate !•$ Select B Back
3. In the Picture Size field, select either TheaterWide 2 or
TheaterWide 3 (you cannot scroll in any other mode).
Press T to highlight the Picture Scroll field.
5. Press ^ ► to scroll the picture up and down as needed,
from -10 to +20.
4,
Theater Settings
ii Picture Size TheaterWide 2
Cinema Mod«
Auto Aspect Ratio
Reset Done
6. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Using the auto aspect ratio feature
When the Auto Aspect feature is set to On and one of the
following input sources is received, the picture size is
automatically selected (as described in the table below):
• A 480i signal from the VIDEO 1, VIDEO 2, ColorStream
HD 1, or ColorStream HD 2 input.
• A 480i, 480p, 1080i or 720p signal from the HDMI input.
Aspect ratio
of signal source
Automatic aspect size
(automatically selected
when Auto Aspect Is On)
4:3 normal Natural [with sidebars)
4:3 letter box TheaterWide 2
16:9 full Full
Not defined
[no ID-1 data or)
HDMI aspect data)
User-selected picture size
[see pages 65-66)
Note:
• The auto aspect ratio feature is not applicable to antenna or Cable input
sources.
• The auto aspect ratio feature is not available when the FREEZE mode is
active, or the TV Guide On Scree/?™ system is open.
To turn on the auto aspect ratio feature:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
i /7^1 \[fl
Si Picture Settings
I Advanced Picture Settings |
3. In the Auto Aspect Ratio field, select On.
Theater Settings
Picture Size
Picture Scroll
Cinema Mode
Auto Aspect Ratio
Reset
TheaterWide 3
-1
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
To turn off the auto aspect ratio feature:
Select Off in step 3 above.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 67