6j sewng up your tv, Selecting the menu language, Configuring the antenna input sources – Toshiba 32HLX95 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6J SeWng up your TV
For menu navigation instructions, see Chapter 4.
Selecting the menu language
You can choose from three different languages (English, French
and Spanish) for the on-screen display menus and messages.
(The TV Guide On Screen™ menus are in English, regardless of
the language selected in this menu.)
To select the menu lang^xage:
1. Press MENU and open the Preferences menu.
2. Highlight Menu Language and then press ►.
3. Press
AT
to select your preferred menu language and then
press ENTER.
C:\
11
ê m
I Favorite Channels
I Closed Caption Mode off
I
Closed Caption Advanced
I
input LalDeiing
Menu Language Errglieh»-
Français
Español
I
Home CH Setup
{#} Navigate I#! Select Hi>:lii!l Back Exit
Configuring the antenna input
sources
To configure the ANT 1 and ANT 2 input sources:
1. Press MENU and open the Setup menu.
2. Highlight Installation
and press ENTER. (A
new set of Installation
menu icons will appear
on-screen, as shown in
step 3 below.)
Sleep Timer
Si On/Off Timer
iii PC Settings
HDMI Audio
Auto
iii Gray Level 2
Navigate (•I Select Bniïïï?l Back f
3
!ffi Exit
3. open the Terrestrial menu, highlight Input Configuration,
and press ENTER.
Note: The Terrestrial menu may not be accessible [items will
be “grayed out”] in some instances [for example, if a cable
box is connected to tbe ANT
/ input or if one oftbe VIDEO
modes is tbe current input during TV Guide On Screel^
setup].
Si Input Configuration ss;
si Channel Program
iii Channel Add/Delete iii
iii Signal Meier
Navigate нн#н Select ltl!l!)i;i Back Í
3
HÍ
1
Exit
4. Press ^ ► to select the input source (Cable or Antenna) for
the ANT 1 input on the TV.
Note: If a cable box is connected to the ANT
/ input during
TV Guide On Screen™ setup, the entire Terrestrial menu will
not be accessible, including tbe input source for ANT I, which
will automatically display “Cable Box.”
5. Press
T
and then ^ ► to select the input source (Cable or
Antenna) for the ANT 2 input on the TV, if applicable. If
you have not connected anything to ANT 2, skip this step.
input Configuration
Antenna fin
ii Antenna 2 in
Antenna
Done
6. To save your new settings, highlight Done and press
ENTER. To revert to your original settings, highlight
Cancel and press ENTER.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
39