Toshiba 32HLX95 - Manual (Page 41)

Chapter 6: Setting up your TV
Programming channels into the TV’s channel memory (continued)
Manually adding and deleting channels in
the channel memory
After automatically programming channels into the channel
memory you can manually add or delete individual channels.
To add or delete channels in the channel memory:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3).
;s Sleep Timer
I On/Off Timer
|PC iSettlngs.................
HDMI Audio Auto
Gray Level 2
t^i Navigate !•! Select iH!l;ii>'l Back
3. open the Terrestrial menu, highlight Channel Add/Delete,
and then press ENTER.
S L7'
Input Configuration
si Channel Program
'% Select CUM Back l=f!ni Exit
The illustration below left shows channels programmed for
the ANT 1 antenna input. To view the list of channels
programmed for ANT 2 or Cable box antenna input, use
AT to select the “ANT 2” or “Cable Box” and press
ENTER.
Note: “Cable Box” will appear only if you connected a cable
box to your TV.
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number
you want to add, and then press ENTER to check the box.
To manually add digital subchannels on a physical channel:
Use the Channel Numbers and the Dash (-/100) on the
remote control to enter the channel number (for example,
56-1).
If the channel is found, the number will be added to the list
and the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press ENTER to uncheck the
box.
To save your new settings:
Highlight Done and press ENTER.
To revert to your original settings:
Highlight Cancel and press ENTER before saving.
To remove all channels from the channel memory:
Highlight Reset and press ENTER.
Note:
• This action applies to the current antenna input only To
delete/add channels on the other input, highlight the input
you want [ANT 1 or ANT 2] and press ENTER.
• This action cannot be cancelled unless you highlight Cancel
and press ENTER before saving your changes.
Channel Add/Delete
□
□
Analog
Digital
Digital
Analog
Analog
Analog
Analog
Analog
Digital
Analog
® ANT 1
I
O ANT 2
I O Cable Box |
Reset
Cancel
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 41