Rules for installing dimms, Installing dimms – Toshiba V1100 User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Memory configurations
The following shows some typical memory configurations:
Memory Desired
DIMM size
Number of DIMMs
64 MB
64 MB
1
128 MB
128 MB
1
128 MB
64 MB
2
256 MB
128 MB
2
512 MB
256 MB
2
768 MB
256 MB
3
Rules for installing DIMMs
Keep the following items in mind when adding or replacing DIMMs.
□ DIMM sockets do not need to be installed in triples.
□ DIMM sockets can be filled in any order.
□ The DRAM timing register is programmed to use the tim ings of the
slowest DRAMs installed.
Installing DIMMs
The following procedure assumes you have opened the case and are
observing ESD precautions. (Refer to " Opening the case") To install
DIMMs:
1. Holding the DIMM only by the edges, remove it from its antistatic package.
2. Make sure the clips at either end of the socket are pushed away from
the socket.
3. Position the DIMM above the socket at about a 90-degree angle
relative to the motherboard.
Make sure the two small notches in the bottom edge of the DIMM
align with the keys in the DIMM socket.
3-10 Hardware for the V1100
User's Manual