Graco SnugRide 1778253 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Push the infant restraint down into the base
and make sure that you hear a “ciick” O.
Puii up on the infant restraint to be sure it
is iatched secureiy into the base.
if the infant restraint does not secureiy iatch
into the base, the infant restraint provides
NO protection for your chiid. DO NOT use
the infant restraint/base if the infant restraint
does not secureiy iatch into the base.
8. Test infant restraint for secure
instaiiation as described in infant
restraint “Final Safety Check” page 41.
7.3 Using LATCH to install Base
1. MAKE SURE vehicle is on level ground.
For ease of installation, extend LATCH to its
maximum length and remove from storage
bars.
2. Position base in vehicle seat as shown.
3. Make sure LATCH is through vehicle/LATCH
belt path normally used for vehicle seat belt
O.
Belt must lay flat and not be twisted.
4. Hook connectors to vehicle lower anchors.
Pull firmly on connectors to be sure they are
attached ©.
37